Before attempting to fit the cubicle(s):

• familiarise yourself with the site drawings and/or the working drawings supplied with the cubicle(s).
• check that all components and ironmongery are correct.

1. Measure and mark the positions of all the partitions on the back wall.
2. Using a plumb line or a spirit level, draw the centre lines on the back wall and floor.
3. Fix 3 "U" brackets for each partition on the centre line using the rawl plugs and screws provided. Note that if fitting the FOREST range the partitions are fixed to the wall using the flange of the aluminium extrusion already fitted to the partition. If fitting the ATOLL range then the wall channel is used instead of the brackets.
4. Using a 150mm block to support the partition, insert the partition into the brackets. If the wall is not straight you will need to either put packing behind the brackets or scribe the partition to the wall.
5. Once you have the partition in place then drill through the partition using the hole in the bracket as a guide and fix using the through bolts provided. If fitting the Atoll range then drill through using the holes in the wall channel as a guide and fix using the through bolts provided.
6. Disassemble the hinges and fix the female half of the hinge to the pre-drilled fascias using the "T" nuts provided.
7. Fit the leg to the pre-drilled fascias using the through bolts provided.
8. Mark the centre line on the back of the centre fascia and along the edge of any end fascias.
9. Fix 3 "U" brackets to each fascia using the 5/8" screws provided. If fitting the ATOLL range then the wall channel is used instead of the brackets.
10. Offer the fascia up to the partition, drill through the partition using the hole in the bracket as a guide and fix using the through bolts provided. If fitting the FOREST range then use the flange on the aluminium extrusion to fix fascia to the partition. If fitting the ATOLL range then use the holes in the wall channel as a guide, drill through the partition and fix using the through bolts provided. After installation of the fascia, refer to the drawing supplied, mark the appropriate headrail position, pre-drill and fix the headrail.
11. Fix the leg to the floor using the rawl plugs and screws provided. Cut to length the capping rail and fix through the top of the fascias making sure the door openings are correct. Any adjustments because of uneven floors can be made on the legs prior to final fixing.
12. Disassemble the indicator bolt and fit to the pre-drilled door.
13. Fix the male half of the hinges to the pre-drilled door edge.
14. The door can now be lifted onto the hinged fascias and locked in place using the anti-lift off screw. By adjusting the nylon bushes the door can be set to fall shut or fall open. The keep and the rubber buffers can now be fixed to the inside of the clashing fascias. Any accessories can now be fitted to the cubicle/s.

Finally, the cubicle/s can be wiped down using a damp cloth with a mild non-abrasive detergent.